Are you one of those who say the extender setup is difficult? It is not difficult although many users report the same. But, we are up with a lot of setup tips.

What Exactly Needed For Extender Setup

Rockspace extender Login offers back the WLAN signal of any router or access purpose. It also provides an online association in those places wherever the internet does not reach simply. However, some necessary tips for extender setup square measure.

Changing Brostrend Extenders Default Password

The ‘admin’ is the default password for the Rockspace extender. Although, if you want to change the password then follow the below-given steps:

WPS Methodology of Rockspace Extender

• WPS is the security normal for a wireless association that helps in creating a steady association between wireless devices or extenders. There square measures 2 ways in which to set up an extender by victimizing the WPS.

Use The Web-Based WPS Button

• To begin with the process, it offers you three choices within the WPS net based mostly.
• Therefore, use the WPS button, utilize the WPS pin, and use the router PIN.
• After that, set the time zone and your location, if necessary.
• Set the wireless network name (SSID) and password that you want to use with your Rockspace device, if applicable depending on which model of extender you have.

Note: Lights play an important role RED and Orange Lights are always an indication of a poor connection. Or sometimes no connection at all.

Possible Extender Setup Errors

While configuring the rockspace wifi extender, there could be serious errors. However, these errors can come because of a few points that might have been missed earlier. These are listed below –

• Devices are far from each other.
• The web browser is an outdated version
• The connection to the internet is not too good
• The extender is still running on an outdated version.
• The entered spelling for the site address might be wrong.

These can be a few small details that need to be followed while going forward to extend the WiFi range of the router with the help of the wifi range extender.

Troubleshoot the Extender Problems

Keep things in mind that could be tough so just have a look at this last easy guide. A troubleshooting guide. Yes, to troubleshoot the problems we need to make sure the wires are in a good connection or not. Secondly, devices are equally near. Lastly, see if the existing router is in the right place or not.

We hope the blog is informative and gives you thorough guidance on the Rockspace extender login and setup.

Why Doesn’t The Extender Connect With The Router?

You think there is only one reason behind the bad connection of the WiFi extender and router. The reasons are written-below

• The connection of the ethernet wire with the Rockspace WiFi extender as the power LED light is necessary to light up.
• The reset process was not accurate. Because of this, the extender is in partial connection.
• The proximity of the devices is far. So move them closer.
• If the router’s configurations are not right
• Finally, check if the router’s firmware is old or new.