There are so many ways to fix the re.rockspace.local setup issue but we will tell you only three tips. By following these tips you can quickly fix the Rockspace extender issues.
Settle Rockspace Device Closer To Router
Due to the maximum gap between the router and extender, you can face issues. To fix the issues we recommend that you place both extender and router gadgets near each other. Also, make sure that extender and router gadgets don’t settle near metal or electronic gadgets because they absorb all the WiFi signals which come from the extender and router gadgets. By doing this you can easily remove the Rockspace WiFi range extender issues.
Improve Or Get The Latest Rockspace Extender Software
To improve or get the latest Rockspace extender software version consider the below steps.
First, visit the re.rockspace.local setup management page. After visiting, look for the administration option and then pick the software upgrade option. Now, if you see the latest version of a software file then install it on your laptop or computer. Further installing the software file you will need to restart the Rockspace extender to complete the software or firmware upgrade process.
Off/On Test Rockspace Extender
First, turn off the Rockspace WiFi range extender. After that, take out the power plug of the Rockspace extender in the power socket. Next, wait for a while and turn on the Rockspace extender. In the end, place the Rockspace extender power plug back into a wall socket.
Reset Rockspace Extender
At the Rockspace extender back you can see the reset button. Push the Rockspace extender reset button on a paperclip. By doing this, all the Rockspace extender LEDs will power off. Thus, it means your Rockspace repeater is now completely reset.
Note: After resetting the Rockspace extender you will need to do the login and installation process again.
Login Into Rockspace Extender
First, place the Rockspace extender gadget near the router in the power socket. Now, take the computer and join it with the Rockspace extender network. Later, open Chrome and type re.rockspace.local in the address bar. Next, fill in all the details which are shown on the display page. In case, you don’t know the Rockspace extender login details then check the tag or bottom or manual which comes with the Rockspace extender device.
Configure Rockspace Extender
By pressing the Rockspace extender WiFi-protected setup button you can quickly do the Re.rockspace.local setup process.
First, place the Rockspace extender unit near the existing router. After that, press the Rockspace extender WPS button and within 20 seconds press the existing router WPS button. By doing this, the WPS LED starts blinking solid on both the extender and router gadget. Therefore, extenders and routers are completely linked with each other.
By following the above solution tips the Rockspace WiFi range extender issues are now fixed. In case the above solution tips don’t help you to fix the extender issue then try to ping our Rockspace technical support team.
