care@re-rockspacelocal.com +1 716-992-6370
0 Comments
rockspace extender

Re.rockspace.local is the default web address used to access the WiFi extender’s configuration page. To configure the extender, you need to connect it to your router and access the configuration page using the web address on a web browser. Once on the configuration page, you can follow the on-screen instructions to set up and customize your extender’s settings. Some simple methods for re.rockspace.local include resetting the extender to default settings, updating the firmware, and changing the extender’s network credentials.

Go To The Extender’s Sign-In Page

To access the WiFi extender sign-in page. You’ll first need to connect your computer or mobile device to the WiFi extender’s network. Once connected, open your preferred web browser and type “re.rockspace.local” into the address bar. By clicking this, you will be directed to the login page for the extender. Unless you’ve changed the password and username previously, you’ll see “admin” and “password” as defaults. After logging in, you can access the WiFi extender’s settings and configure it to meet your specific needs.

Do Your Device Configuration Via WPS

Setting up the extender via WPS is a quick and easy process. A few easy steps will guide you through the process. Before starting the process, ensure that your device turns on and locates within the range of your WiFi network.

To begin with, locate the WPS button on your device and press it. This will activate the WPS mode, and the LED light on the device will start blinking.

Locate your router’s WPS button next. After that, press it within two minutes of pressing the WPS button on the device. The two devices will then establish a connection and the LED light on the extender will stop blinking.

Once you make the connection, you can access the re.rockspace.local device from your computer or mobile device. By connecting to the WiFi network created by the device. You can then follow the on-screen instructions to complete the setup process and configure your device according to your preferences.

Configure Rockspace Extender Through IP

To configure your WiFi extender through an Ethernet wire, follow these steps:

  • Connect your computer or laptop to the Rockspace extender using an Ethernet cable.
  • Launch a web browser and enter the default IP address of the WiFi repeater. Which is typically 192.168.0.1, in the address bar.
  • Your username and password will be asked to fill in. It recommends using “admin” as both the password and username.
  • Once you are logged in, you will see the extender’s setup wizard. Set up your extender by sticking to the directions.
  • Identify the wireless network you wish to connect to and enter the password for that network. You may also need to choose a new SSID and password for the extender.
  • Once the configuration is complete. Disconnect the Ethernet cable and place your extender in a central location between your router and the area. The location where your wireless network needs to be expanded.
  • Connect your devices to the extender’s wireless network and enjoy a stronger, more reliable WiFi signal.

After reading this post, our re.rockspace.local process will be complete. In the other scenario, if you are facing any error then contact our technical team. Our technical team information is +1 716-992-6370 or you can mail us at care@re-rockspacelocal.com.


Disclaimer:- re-rockspacelocal.com website is for the customers, seeking technical help and technological assistance for WiFi extenders, routers and WiFi networks. However, we do not have any endorsement , alliance or affiliation with any brands neither direct nor indirect. All the images, brand names, product models, logos are only for illustrative purposes. Guidelines provided in the website are solely for informational purposes. Neither a guarantee nor an implied warranty is provided regarding the content available on the website.